PRODUCT NAME SLTB04 Anti-rust Hard-film Paint

BRIEF One Pack of a variety of resin, special preservative, pigment consistings Anti-rust.

FEATURES
 -Excellent corrosion resistance anti-aging and medium
-Good resistance to hot and humid and fog-corrosion
-Anti-pulverization, resistance to crack the outstanding performance
-High gloss, fast drying
-Excellent performance and the light protective coloration

RESISTANCE GUIDE 
To all sorts of metal and its products are very good anticorrosion performance.
Situated in a special environment of mass open-air deposited metal products such as tubing, rail, steel pipe, etc. Have good anticorrosion role.

USES:Widely used in steel tubing, rail, and machine tools, and the surface of an important steel structure decoration and protection.

TYPICAL PROPERTIES AND APPLICATION DATA 
 COLORr:               various
 VISCOSITY (4 cups) :      with 10 ~ 30s
 ADHESION :              ≤2 grade.
 FLEXBILITY:              ≤2mm
 THE COTENT OF SOLIDY:      ≥30%
 SALT-FOG SEX:             ≥72 Hr
 DRYING TIME (23 ℃) :    Touch  ≤1 0 min   Handle ≤ 24Hr

DIRECTIONS Stir contents of each can thoroughly with a broad flat stirrer using a stirring, lifting action or use a power mixer. Rate of cure will vary depending on temperature and other factors such as ventilation, film thickness, humidity, thinner. The temperature of stir will >15℃, otherwise thinner should be added for needed viscosity after stir.
Overmuch thinner will lead sag and slow cure rate, thin film. Practical spreading rates may be reduced 5-25% for wastage of different application conditions.

APPLICATION  STEEL: Round off all rough welds, sharp edges and remove weld spatter. Remove grease, oil and other contaminants. Steel surface must be prepared by abrasive blast cleaning to ISO Standard Class Sa2.5 or power tool cleaning Class St3.
Don’t apply at air temperature below 5℃ or above 40℃. Don’t apply at relative humidity above 85% or when air temperature is less than 3℃ above the dew point.
Don’t apply if there is fog, rain, snow or strong wind. 
BRUSH/ROLLER: Suitable for small areas only. Apply even coats of the mixed material to the prepared surface. Thin if necessary with up to 0-15% with Special Thinner X-13. Additional coats may be required to attain specified thickness. 
CONVENTIONAL SPRAY: Thinning is not normally required, however 0-15% of Special Thinner X-13 can be added.
AIRLESS SPRAY: Thinning is not normally required, however 0-15% of Special Thinner X-13  can be added.
Overcoating: Aged coating should be tested for lifting by a method such as ‘X’cut or crosshatch methods. If it lifts, remove it. The surface must be free of oil, grease and other contaminants.
CLEAN UP: with Special Thinner X-13

SAFETY: Pay attention to the safety precautions before and after using this product. Users should comply with the provision of the respective country or local government. It’s dangerous or deadly to eating it. To avoid inhalation of thinner steams and spray mists.
Use protective wears correctly; the skin and eyes should avoid contacting it. Use with good ventilation. This product is flammable. All sources of ignition must be eliminated in, or near the working area. DO NOT SMOKE. Fight fire with foam, CO2 or dry chemical powder. On burning will emit toxic fumes.

Notes: The data in the manual is get from standard experiments and may be vary from different conditions in use. Please refer to the latest manual if the data is altered and we would not inform specially.