PRODUCT NAME SLC53 Turns Alkyd Paint

BRIEF One Pack Primer made from Alkyd resins, additives, red lead, etc pigments and extenders

FEATURES
-Excellent adhesion on steel substrates
-Excellent rust resistance
-Paint film is tough

RESISTANCE GUIDE
HEAT RESISTANCE  Up to 80℃ dry heat
WEATHERABILITY   Should not be long exposure, should be timely coating top-coat
SOLVENTS         Resists solvents such as alcohol, mineral oil and other solvents.
ACIDS              Do not recommend contacting with splash and spillage of acids fog and solution.
ALKALIS          Do not recommend contacting with splash and spillage of alkalis fog and solution.
SALTS              Do not recommend contacting with salts solution.
WATER            Do not suitable for long-term immersion and humidity
ABRASION     Good when fully cured.


USES:Widely used on steel surface as general protection

TYPICAL PROPERTIES AND APPLICATION DATA
COLOR                      Orange
DENSITY                     1.4g/cm3
SOLIDS BY VOLUME            43%
SOLIDS BY WEIGHT             72%
SPREADING RATE               7.7 m2/kg (40um DFT)
DRYING TIME(23℃)             Touch 5 Hr    Handle  24 Hr   
OVERCOAT INTERVAL(23℃)       Min  24Hr
STORAGE                         at least 12 months (dry, cool and under cover )
PACKAGING                     20kg

DIRECTIONS   Before using stir or using dynamic mixer mixing two components completely. Rate of cure will vary depending on temperature and other factors such as ventilation, film thickness, humidity, thinner. The temperature of stir will >15℃, otherwise thinner should be added for needed viscosity after stir. Overmuch thinner will lead sag and slow cure rate, thin film, thinner should be added after mixed. Practical spreading rates may be reduced 5%—25% for wastage of different application conditions.

APPLICATION  

STEEL: Round off all rough welds, sharp edges and remove weld spatter. Remove grease, oil and other contaminants. Steel surface must be prepared by abrasive blast cleaning to ISO Standard Class Sa2.5 or power tool cleaning Class St3.
Don’t apply at temperatures below 5℃ or above 45℃. Don’t apply at relative humidity above 85% or when the surface is less than 3℃ above the dew point.
Don’t apply if there is fog, rain, snow or strong wind.
BRUSH/ROLLER: Suitable for small areas only. Apply even coats of the mixed material to the prepared surface. Thin if necessary with up to 0-15% with Alkyd Thinner X-1. Additional coats may be required to attain specified thickness.
CONVENTIONAL SPRAY: Thinning is not normally required, however 0-15% of Alkyd Thinner X-1 can be added.
AIRLESS SPRAY: Thinning is not normally required, however 0-5% of Alkyd Thinner X-1 can be added. Pump ratio is 23:1 or 32:1 and fluid tip is 0.38-0.43 mm.
Overcoating: Aged coating should be tested for lifting by a method such as ‘X’cut or crosshatch methods. If it lifts, remove it. The surface must be free of oil, grease and other contaminants.
CLEAN UP: with Alkyd Thinner X-1


SAFETY: Pay attention to the safety precautions before and after using this product. Users should comply with the provision of the respective country or local government. It’s dangerous or deadly to eating it. To avoid inhalation of thinner steams and spray mists. Use protective wears correctly; the skin and eyes should avoid contacting it. Use with good ventilation. This product is flammable. All sources of ignition must be eliminated in, or near the working area. DO NOT SMOKE. Fight fire with foam, CO2 or dry chemical powder. On burning will emit toxic fumes.

Notes: The data in the manual is get from standard experiments and may be vary from different conditions in use. Please refer to the latest manual if the data is altered and we would not inform specially.